banner

banner-1
ba-2
banner-4
banner-3-1
You are here: Home » News » Industry News » Stainless Steel Flange Rust-related Knowledge

Stainless Steel Flange Rust-related Knowledge

Views: 0     Author: Site Editor     Publish Time: 2023-12-11      Origin: Site

Stainless steel flange seven big derusting process

1. Remove rust before removing all kinds of visible dirt on the surface, and then use solvents or detergents to remove oil.

2. With tungsten carbide shovel shovel to large area rust.

3. With the scraper and wire brush to remove the corners of the rust.

4. With a file to remove the solder slag and other highlights and a variety of burr.

5. Clean with emery cloth and wire brush.

6. With a clean rag, can also be used dishcloth dip solvent for cleaning and timely painting primer.

7. Pay attention to the toughness of the film has not yet expired, can be retained, and used emery cloth to beat the old paint surface, the film defects will be polished into ax-shaped, clean directly after painting.

Second, stainless steel flange rust removal tool

1.Knocking Rust hammer-also known as a shovel hammer, usually two ends have a blade, one end is “a” type, the other end is “│”, the blade is about 20mm wide, mainly used to knock off the surface of rust, loose oxide skin and old coating. There is also a pointed hammer with a sharp tip, which is used to remove rust from the depths of the depression.

2. Shovel knife-knife length about 50~100cm, wooden handle or hollow steel pipe production, blade wide 40mm~20cm, with carbon steel or tungsten carbide production. It is mainly used to eliminate corrosion, oxide, old coating and dirt in plane.

3. Scraper-commonly known as “scraping planing”, a flat, a curved, both sides with a blade, made of carbon steel, the length of about 20cm, the role of the flat head with the shovel knife, elbow used in addition to angle and rust and dirt; there is also a pointed scraper, elbow end is pointed, used to remove the cracks in the rust and putty and other dirt.

4. The steel wire brush–divides into the long handle and the short handle, the brush end face uses the fine steel wire to be strung, uses in the other tool to remove the rust trace and the residue which leaves after the shovel; another kind of steel wire beam at both ends is used for the gap and the hole position.

5. File-there are planes, triangles and other shapes, mainly for the removal of welding slag and other prominent hard objects.

6. Emery cloth, sandpaper


We have an excellent technical team, our products in quality and quantity will make you satisfied, welcome to buy
  • 86-316-5120812
  • Mon-Sat: 09:00AM - 05:00PM
  • Room1-3-908 Zijincheng Commercial Building, Guangyang District, Langfang City,Hebei Province,China
CONTACT US
We have an excellent technical team
Incorrect E-mail
Follow Us
Copyright ©Langfang Dingyang Flange&Pipe Fitting Co.,Ltd 1998-2024. All Rights Reserved.                                                                                                                      Support By yiwaimao.cn